| IF THE PROBLEM IS: |
AND THIS CONDITION EXISTS: |
THEN DO THIS: |
| Pilot won’t light |
Cylinder valve is closed |
Open valve |
| Blockage in orifice or pilot tube |
Clean or replace orifice or pilot tube#
|
| Air in the gas line |
Open gas line and bleed it (pressing control knob in) for not more than 1-2 minutes or until you smell gas |
| Low gas pressure |
Gas cylinder low or empty |
| Igniter fails |
Use match to light pilot, and obtain new igniter and replace. ( See below pictures)
|
| Pilot won’t stay lit |
Dirt build up around pilot |
Clean dirt from around pilot |
| Connection between gas valve and pilot assembly is loose |
Tighten connection and perform leak test |
| Bad tهرموکوپل
|
ترموکوپل را تعویض کنید |
| Burner won’t light |
Gas pressure is low |
Replace gas cylinder |
| Blockage in orifice |
Clear blockage |
| Control knob is not in "ON" position |
Turn control knob to "ON" position |
| Burner flame is low |
Gas pressure is low |
Replace gas cylinder |
| Note: Do not operate heater below 5℃(40°F)
|
Outdoor temperature is greater than 5℃(40°F) and tank is less than 25% full
|
Replace gas cylinder |
|
Supply hose is bent or kinked |
Straighten hose and perform leak test on hose |
|
Control knob is fully " ON" |
Turn control knob to "OFF", let it cool to room temperature and check burner and orifices for blockage |
| Emitter glows uneven |
Gas pressure is low |
Replace gas cylinder |
| Note: Bottom 2.5cm of emitter normally does not normally glow |
Base is not on a level surface |
Place heater on a level surface |
|
Heater not level |
Level heater |
| Carbon build-up |
Dirt or film on reflector and emitter |
Clean reflector and emitter |
| Thick black smoke |
Blockage in burner |
Turn control knob to "OFF", let it cool to room temperature and remove blockage and clean burner inside and outside. |
EN 
ES
PT
SV
DE
AR
FR
