IF THE PROBLEM IS: | AND THIS CONDITION EXISTS: | THEN DO THIS: |
Pilot agaghị amụnye ọkụ | A na-emechi valvụ sịlịnda | Mepee valvụ |
Ngọngọ na orifice ma ọ bụ pilot tube | Hichaa ma ọ bụ dochie orifice ma ọ bụ pipụ pipụ# |
Ikuku na ikuku gas | Mepee ikuku gas ma gbanye ya (pịa akara aka) maka ihe karịrị 1-2 nkeji ma ọ bụ ruo mgbe ị na-anụ gas |
Obere ikuku gas | Gas cylinder dị ala ma ọ bụ ihe efu |
Igniter adaala | Use match to light pilot, and obtain new igniter and replace. ( See below pictures) |
Pilot agaghị anọ n'ọkụ | Dirt build up around pilot | Hichaa unyi si gburugburu pilot |
Njikọ dị n'etiti valvụ gas na mgbakọ ụgbọelu adịghị | Kesie njikọ ike ma mee ihihi ule |
Bad thermocouple | Dochie thermocouple |
Ọkụ agaghị enwu | Mmetụta gas dị ala | Dochie cylinder gas |
Mgbochi na orifice | Kọwaa mgbochi |
Control knob is not in "ON" position | Turn control knob to "ON" position |
Ọkụ ọkụ ọkụ dị ala | Mmetụta gas dị ala | Dochie cylinder gas |
Note: Do not operate heater below 5℃(40°F) | Mpụga dị n’èzí karịrị 5℃(40°F) and tank is less than 25% full | Dochie cylinder gas |
| Tụkwasịnụ sooks bụ kpudo ma ọ bụ kinked | Rụzie sooks ma mee uhi ule na sooks |
| Control knob is fully " ON" | Turn control knob to "OFF", let it cool to room temperature and check burner and orifices for blockage |
Emitter na-enwu enwu na-enweghị atụ | Mmetụta gas dị ala | Dochie cylinder gas |
Rịba ama: Ala ala 2.5cm nke emitter anaghị ejikarị egbukepụ egbukepụ | Ntọala adịghị na ọkwa dị larịị | Debe ikpo oku na ọkwa dị larịị |
| Heater bụghị larịị | Ọkwa kpo oku |
Nrụpụta carbon | Unyi ma ọ bụ ihe nkiri na ngosiputa na emitter | Clean reflector na emitter |
Oké anwụrụ ọkụ ojii | Mgbochi na ọkụ | Turn control knob to "OFF", let it cool to room temperature and remove blockage and clean burner inside and outside. |